Bobrick Trimline Cartridge Foam Soap Dispenser 1000ml

£218.64 £182.20
Or
Discount code
Apply Remove
  • Bobrick TrimLine Cartridge Foam Soap Dispenser
  • Capacity 1000ml
  • Can also be used for Bulk Fill
  • Stainless Steel
  • Brushed Satin Finish
Availability: In stock
Quick Code :
11026
Warranty :
1 Year
Brand :
Bobrick
Delivery :
2-3 Days
Sku :
B-26637

Bobrick TrimLine Cartridge Foam Soap Dispenser 1000ml is manufactured from type 304 stainless steel with a brushed satin finish

Plastic container can be used for soap cartridges (up to 1000 ml), as well as bulk refilling

Hinged housing with key lock, all locking accessories are keyed alike for ease and convenience of maintenance.

Capacity: 1000ml.

Valve operates with less than 22.2N of force,

Product Code Colour Capacity Height (mm) Width (mm) Depth (mm)
 B-26637 Brushed Satin   1000ml 336 96 153

 

MATERIAL:

Welded, 0.8mm (22 gauge) 1.4301, Type CrNi 18/10, AISI 304 stainless steel housing with satin finish; stainless steel operating lever; metal lock and key; soap level indicator; interchangeable plastic containers with plastic pumps; variety of plastic containers available including containers with pumps for soap or foam.

 

OPERATION:

The cover is lockable with a Bobrick System lock. To refill the dispenser, open the cover by lifting and pulling forward. The soap level indicator shows how much product is remaining in the dispenser. The plastic container can be removed and re-installed for quick and easy refilling. The plastic container can be used for foam soap cartridges (up to 1000 ml), as well as bulk refilling of up to 1000 ml of foam soap. To install a soap cartridge in the dispenser, open the cartridge and place it upside down inside the plastic container. Alternatively, soap can be poured directly into the plastic container. The dispenser has been designed for quick and easy refilling process.

 

INSTALLATION:

After opening the dispenser cover, remove the plastic container, gently lifting it upwards while pressing the locking latch. Mount the dispenser to the wall by using the enclosed screws and wall plugs. Make sure the wall surface is in good condition to ensure proper mating of the dispenser to the wall. Use silicone or glue pads if necessary.

Note:

1. The dispenser should be installed near or directly above the sink to allow wet hands to drip into the sink.

2. Allow sufficient space above dispenser to exchange cartridges easily.

3. Recommended installation height: 100 – 110 cm (measured from floor to the bottom of the dispenser).

 

TECHNICAL SPECIFICATIONS:

Model B-26637 from Bobrick Washroom Equipment, Dispenser made of 0.8 mm thick, (22 gauge) 1.4301, Type CrNi 18/10, AISI 304 stainless steel with a brushed, satin finish; plastic container for soap cartridges (up to 1000 ml), as well as for bulk refill of soap (up to 500 ml); lockable with a Bobrick System lock; soap level indicator.

 

CARE INSTRUCTIONS:

Clean regularly with warm water and/or stainless steel cleaner. Do not use acid (chloride) cleaners or scouring agents. The suction valve can be cleansed by pumping hot water through it. Do not dismantle the dispenser. Use only original spare parts.

We found other products you might like!